Below are the available bulk discount rates for each individual item when you purchase a certain amount
Quanity of (1) means (2x) faceplates. Leave "quanity" at (1) to order a (pair) of plates.
Our Technics 1200 face plates have been designed for light weight portablity so that you may easily take them from the studio to the club. The semi-flexible, yet WARP free physical properties of these acrylic plates will always lay flat making 100% surface contact and will not interfere with your performance.
These are LASER cut from out of 3mm thick acrylic. The mirror finish of the acrylic offers a stunning appearance.
In addition, we are the FIRST to offer face plates with an optional 45 hole cutout for Dj's who use the Novation "DICER".
Plates also come with an ACRYLIC POLISH in the unfortunate event of any minor surface scratches.
Finger prints that may appear on mirror finish can be easily cleaned with a microfiber cloth.
Posted by Unknown on 2nd Jan 2013
Posted by DJ Ollie on 13th Oct 2012
Very shiny and clean, but only one thing...I use the Novation Dicers frequently and they don't fit as tight and flush compared to not having the faceplate cover on... An easy work around is to shave out the inside with a sharp knife or filer...
Overall makes my scuffed up MkIIs look like they brand new!
12inchSkinz says. Have not noticed this on our 1200's but using sandpaper or filer sounds like a good remedy if you have this issue.
Posted by DJ Ace the Crowd Motivator (NYC) on 28th Apr 2012
Shiny acrylic finish is hot but I'm experiencing some lift in the front and the pin whole to depress to raise the lamp is too deep,had to stick the pin from an RCA cable to press the whole to get the lamp to ascend.Other than those 2 small issues,the plates look great.
12inchSkinz says: when installing plate, move tone arm to center of platter, press button to extend strobe light and then place face plate over power button and strobe. Strobe light should already be extended before install.